DIY Boho Bracelet

Create this DIY Boho Bracelet and make it a fun piece for any wardrobe!

DIY Boho Bracelet_Artzy Creations 12

Here’s a fun tutorial for you to create the perfect Boho style bracelet using beautiful beads from Happy Mango Beads This piece will be a great addition to any wardrobe.

Supplies Needed:

DIY Boho Bracelet_Artzy Creations

Step 1:  Begin by cutting a piece of thread at least 36″ in length.  Knot the end of the thread.  Thread the needle.  Make sure as you work, to carefully keep the thread from getting tangled.

Step 2:  Cut the piece of cording to 7″.  Keep in mind if you have a larger wrist you will have to cut the cording a little bit longer.  The total measurement for the bracelet is 7.5″.  This includes the end caps, jump rings, and lobster claw clasp.

Step 3:  Take the needle and sew up through the center of your cording and come out the side. Then you can start the beading process.

DIY Boho Bracelet_Artzy Creations 13

Step 4:  I created a pattern with the beads using a small Brass Ethiopian Bead followed by a Brass Hematite Bead, Turquoise Wooden Bead, another Brass Hematite Bead, and ending with a small Brass Ethiopian Bead as shown above.

Step 5:  When sewing, make sure to leave the same amount of space between the bead sets as you create your pattern.

DIY Boho Bracelet_Artzy Creations 3

Step 6:  Repeat this process until the entire side of cording has been beaded.  Repeat this process on the other side as well, making sure to equally space your beads as you did on the other side.

DIY Boho Bracelet_Artzy Creations 4

Step 7:  I also attached mini tassels to the end of my bracelet. I wrapped gold wire around the tassel after I threaded the larger jump rings through the tassel.  I also added a few extra jump rings before I glued on the end caps.  This entire step is optional, but it adds for a nice detail to your bracelet.

DIY Boho Bracelet_Artzy Creations 6

Step 8:  Using the E-6000 glue, glue the end caps to each end.  Let this sit for a couple of hours or over night to ensure that the cording is really secured to the end cap.

Step 9:  Open up the both jump rings and attach them to both ends of the end cap.  Before closing one jump ring, attach the lobster claw clasp, and then close.

DIY Boho Bracelet_Artzy Creations 9

There you have it!  It’s so fun and cheery.  Enjoy your fun DIY Boho Bracelet!


Related Posts Plugin for WordPress, Blogger...

Leave a Reply

Your email address will not be published. Required fields are marked *